N333000 ALTUK Rev1 11/15
Amendment to instruction manual RN333000MUK Rev1
Steam Generator with
Replacing the antiscale cartridge (14)
The product uses an antiscale cartridge to help
extend its life. The antiscale indicator (27) will
illuminate to prompt you to replace the antiscale
cartridge which is located in the base unit
the bottom of the iron rest plate (13). The
antiscale indicator (27) will go out only after the
antiscale cartridge has been replaced.
The appliance must be plugged in and switched
ON whilst changing the cartridge, otherwise
the antiscale indicator (27) will not go out.
Remove the iron (7) from the iron rest plate (13)
(unlocking from the iron-to-base lock (12) if
necessary, see step 5 of ‘Using the Steam
Generator for steam ironing’ on page 8).
CAUTION: The cartridge may be very
hot. Be careful when releasing the old
Press down on the old antiscale cartridge (14)
and release, it will then pop up out from its
position in the base unit.
Lift the old cartridge out and dispose of it.
Wait five seconds before inserting the new
antiscale cartridge (otherwise the antiscale
indicator (27) may not go out).
Push the new antiscale cartridge into position
until it clicks into place.
Hold the steam trigger (6) for a minute to pull the
water through the antiscale cartridge and out
through the soleplate
(8) as steam.
NOTE: If no antiscale cartridge is installed, or the
antiscale cartridge is not installed correctly, the
antiscale indicator will continue to flash and the
appliance will not work correctly.